Does your Ford F150 has a red warning popping up in the dashboard? Is it dashboard fault messages pop up?
Maybe it is your Ford F150 tire pressure sensor fault.
A sensor fault isn’t an indication of low tire pressure sometimes it is lower temperatures and your Ford F-150’s tires may have noticed flat tires.
This may have activated the tire pressure warning light, but getting it to turn off in the Ford F-150 might be difficult.
Each time Fault messages pop up in case something is defective.
This guide will show you why this message is there and how to fix it. Ready!
Table of Contents
Top 05 Ford F150 Tire Pressure Sensor Faults
Your F150 ford fault messages are due to the following problems;
1. Temperature difference
There is a warning about low tire pressure on the F150 because the temperature has dropped.
Your TPMS warning light is likely to be on if the temperature difference between when your pressure was the last set and now is what’s making the light go on.
There is less air inside a tire when it gets hot. You need to change the tire pressure in the early winter and early summer to make sure it’s right. You didn’t lose any air from your tires.
It just dropped in pressure as the temperature went down. The same thing happens to all tires, in all cars, no matter what kind of gas is inside them (air or nitrogen).
Tires with low pressure should be topped off with air to get them back up to the set point. Soon after you set the pressures to the right level, the TPMS light should go out again.
If one of the tires becomes lower than other tires by approximately 30% or thereabout, you should seek a tire technician to solve the issue.
2. Ford F150 Dashboard: Warning you have one or more flat tires on your F-150 tires.
Your Ford F-150 is devised in a way that it tells whether one or more tires get flat. In case your light is on, this indicates that one of the tires is flat and you need to stop for a check.
Pullover to a safe place as quickly as you can to look into it. A quick look around isn’t enough. A tire gauge is a helpful means of checking all your tires for pressure.
The Ford F-150’s owner’s manual (as shown below) will also give options on checking what do to in case of a flat tire.
3. F150 Tire Pressure warning – TPMS System Fault
To tell whether your system is faulty or broken, the indicator for Ford’s TMPS comes in handy.
A TMPS malfunction indicator is among the devices equipped in your vehicle that alerts you when there is a system malfunction.
For this reason, the TMPS malfunction indicator works with low tire pressure.
In the instance the system notes a problem, there will be a flash from the telltale for almost one minute and then remain on throughout.
As long as there is a problem with the car, this sequence will keep going when the car starts up again.
Ask for help from a mechanic if you can’t figure out what’s wrong with your TPMS system even though you checked the pressure in your tires with a tire gauge.
A Ford dealer isn’t required. But if your Ford F-150 is still under the original warranty, it would make sense to go there to get your car fixed.
The TPMS system in your Ford F-150 can go bad over time or be damaged. This is like any other system in your truck.
Although the tire sensors can easily be changed, the system will require a restart to continue functioning as usual.
We think that this job should be done by a mechanic or tire expert who knows how the system works and can do the work, but you can try it with the manual.
4. F150 Tire Sealants Warning
Fix-A-Flat and Slime may make your TPMS sensor not work if you use them on your car’s tires.
Tire sealants can damage the sensor that tells you how much air is in a tire. Only use them in a roadside emergency.
5. F-150 Tire Pressure – New Tire or New Tires
New tires for your Ford F-150 might make your tire pressure light come on right away. The pressure requires frequent observation.
Could there be a possible issue that might go wrong? Flats can happen when you drive out of a tire shop’s parking lot and have to stop.
In such an instance, revisit the tire shop and inform them about a system malfunction in the TPWS system of the Ford F-150’s.
A shop may need to start over with the system if they changed the valve stems in the tires, so make sure to do that.
Solutions for the Ford F150 Tire Pressure Sensor Fault
Inflating or deflating tires
The fastest and simplest fix is to check the tire pressure using a reliable air pressure gauge. Parts stores and even most petrol stations have these gauges.
Don’t forget the spare! The spare tire pressure sensor is common yet frequently missed. This is one of the solutions to fix your Ford F150 tire pressure sensor fault.
Sensor Replacement
If you attempt to increase the pressure of the tire according to the recommended specifications and the issue is not resolved, there is a need to replace the tire pressure sensor.
Depending on the model, an OBD2 scanner or the dashboard computer may identify the faulty sensor.
Due to the fact that many car owners cannot dismount or remount a tire, it is essential to make a trip to the nearest tire shop.
The good thing is that the process does not involve high expenses and one can save extra money when they purchase the TMPS sensor.
Sensor Reprogramming
While an automobile scan tool may help you diagnose the issue, a local tire or repair shop can also do a scan to rapidly locate the faulty sensor.
The battery life in the sensor ranges between 2 and 10 years. Many cars including Ford F150 will need to be reprogrammed using the same scanner that discovered the defective one.
The scanner sends the signal from the sensor to the car’s computer, allowing the two to interact.
Since the computer cannot read a new sensor in the absence of the scanner, the dashboard light remains on to indicate the urgent need for reprogramming as part of the replacement.
The reprogramming procedure differs by car model. Some automobiles need a little amount of mileage on the new sensor for the computer to identify it.
Ford Tire Pressure Sensor: What and How Does It Work?
There is an electrical system responsible for monitoring the air pressure in the tires known as a Tire pressure sensor also known as TPMS.
The TPMS’s purpose is to prevent road accidents, poor fuel economy, and increased tire wear caused by under-inflated tires.
Most people associate the Tire Pressure Monitoring System (TPMS) with a bogus dash warning light that must be repeatedly rejected.
If the tire pressure monitoring system detects substantial underinflation in any of the tires, except the spare, it illuminates a warning light.
When the Ford low tire pressure indication glows, you should stop as quickly as possible to inspect your tires and inflate them to the Ford recommended tire pressure.
The tire pressure monitoring device is not a replacement for checking tire pressures manually. One is advised to check the pressure regularly by using a pressure gauge.
How to Disable Tire Pressure Sensor Ford: the Easiest Steps
The Ford F 150 contains a Tire Air Pressure Monitoring System to alert when the tires have insufficient air. Several factors may induce the system to activate.
An exclamation point sits in the midst of the horseshoe. Either repair your tires or reset the system to deactivate them.
Always inspect your tires before turning off the system if the warning light is on. Below, there are two methods on how to disable your ford tire pressure sensor.
Default Tire
Step 1: You should inspect the tires through a physical check.
What you should expect to see is uneven wear, worn thread, and release of air through the cracks, which triggers the monitoring system for air pressure.
Even where the tire contacts the ground, it should seem rounded. The sight of a flattened tire indicates low tire pressure.
Step 2: Disconnect the valve stem cover from the tire’s valve stem.
Place the tire gauge’s end over the valve stem cover’s end. Make that the tire gauge and the valve stem are properly sealed.
Apply pressure on the valve stem using the tire pressure gauge. There is a small pin in the valve stem that prevents pressure to flow out once the cap is taken off.
The air will exit the tire if you press the stem inward. The pressure released to the air will move the gauge that indicates the amount of air that has come out of the tire.
Step 3: Inflate all tires as instructed in the manufacturer’s instructions by using compressed air.
The recommended pressure is printed on the tire’s sidewall. The recommended pounds advised by Ford should not exceed 35 pounds per square inch (PSI).
One should replace the coverings in the valve stem for approximately 20 mph for two minutes.
The Monitoring System in the Tire Pressure should detect the tire air pressure and disable itself.
Faulty Sensor
Step 1: Put off the engine.
Tire pressure sensors on Ford F250 quit operating due to a malfunction. Its light continuously flashes on the instrument panel to distract the driver and possibly cause an accident.
Consequently, you should turn it off.
It is essential that a mechanism is put in place to constantly check the air pressure in the truck’s tire. It first protects the safety of passengers by issuing a warning.
Step 2: Turn the key to light up the instrument panel.
Press the button named “Reset” on the steering wheel’s left side. A reset button can be found in the center instrument panel on some models.
Continue to press the button for about three seconds or after the warning light has gone out.
FAQs on Ford F150 Tire Pressure Sensor Fault
Does a tire pressure monitoring system benefit drivers?
The function of a monitoring system is to provide security and become efficient to the user. It may, for example, be a signal that the tire pressure has dropped below a certain level, requiring quick care.
It shows up as a TPMS sign or a flat tire sign with exclamation points. Poorly inflated tires might create difficulties, so it’s critical to pay attention to these warning lights.
Is driving with a faulty tire pressure sensor safe?
No, driving with a faulty tire pressure sensor is not a smart idea. It’s because the wheels can be underinflated or have other issues that need to be addressed before they can be used on the road. This might lead to tire failure and a blowout.
What is the cost of replacing a tire pressure sensor?
The cost of replacing the tire pressure sensor on a Ford F150 is around $170. However, if you include the labor cost of $50-$70, it will be much more expensive.
Approximately how long do tire pressure sensors last?
The tire pressure sensor typically lasts 5 to 10 years until the battery inside dies. Both the old and new truck models feature lithium-ion batteries that won’t last much longer.
What Is the Essence of the Light from a Flashing Tire Pressure?
What is the meaning of light flashing from the tire pressure light? This might mean that the tire pressure sensors need to be replaced, or that one of the sensors is malfunctioning in general. Schedule service at Jim Hudson Ford near Irmo to diagnose the exact issue. Our technicians can figure out problems very quickly.
What are the symptoms of a Ford F250 tire pressure system failure?
The pressure level within the tire is normally detected by the sensor. They’re necessary to avoid mishaps.
Meanwhile, the indicator indicates that you should stop driving and check the pressure in all of your tires, then fill them to the correct level.
Final Thoughts
Try out all of the remedies for tire pressure sensor failure f150 now that you’ve learned them all.
Choose the best strategy for your vehicle depending on the issues you’re facing. It will also need investment and equipment to solve with simplicity.
However, if you are having difficulty doing so and have money to spare, you should get help from a reputable repair business.
When it comes to tire pressure sensor concerns, don’t waste your time by traveling to a shady location.
Before making any adjustments to your truck’s system, be sure you find the symptoms first.
We hope you find this advice helpful in dealing with the problems caused by a defective tire pressure sensor.